Skip to content
HAM
Trainer
Readiness
◑
Checkpoint
Group T9B
12 questions from the official pool, drawn by ID — exact wording, never retyped.
T9B01
Which of the following connectors should be carefully taped for weather protection when used outdoors?
A
PL259
B
BNC
C
Type N
D
All these choices are correct
T9B02
What is the most common impedance of coaxial cables used in amateur radio?
A
8 ohms
B
50 ohms
C
600 ohms
D
12 ohms
T9B03
Why is coaxial cable the most common feed line for amateur radio antenna systems?
A
It is easy to use and requires few special installation considerations
B
It has less loss than any other type of feed line
C
It can handle more power than any other type of feed line
D
It is less expensive than any other type of feed line
T9B04
What is the major function of an antenna tuner (antenna coupler)?
A
It matches the antenna system impedance to the transceiver's output impedance
B
It helps a receiver automatically tune in weak stations
C
It allows an antenna to be used on both transmit and receive
D
It automatically selects the proper antenna for the frequency band being used
T9B05
What happens as the frequency of a signal in coaxial cable is increased?
A
The characteristic impedance decreases
B
The loss decreases
C
The characteristic impedance increases
D
The loss increases
T9B06
Which of the following connector types is most suitable as an RF connector for frequencies above 400 MHz?
A
PL-259
B
Type N
C
RS-213
D
DB-25
T9B07
Which of the following is true of PL-259 type coax connectors?
A
They are preferred for microwave operation
B
They are watertight
C
They are commonly used at HF and VHF frequencies
D
They are a bayonet-type connector
T9B08
Which of the following is a source of loss in coaxial feed line?
A
Water intrusion into coaxial connectors
B
High SWR
C
Multiple connectors in the line
D
All these choices are correct
T9B09
What can cause erratic changes in SWR?
A
Local thunderstorm
B
Loose connection in the antenna or feed line
C
Over-modulation
D
Overload from a strong local station
T9B10
What is the electrical difference between RG-58 and RG-213 coaxial cable?
A
There is no significant difference between the two types
B
RG-58 cable has two shields
C
RG-213 cable has less loss at a given frequency
D
RG-58 cable can handle higher power levels
T9B11
Which of the following types of feed line has the lowest loss?
A
50-ohm flexible coax
B
Multi-conductor unbalanced cable
C
Air-insulated hardline
D
75-ohm flexible coax
T9B12
What is standing wave ratio (SWR)?
A
A measure of how well a load is matched to a transmission line
B
The ratio of amplifier power output to input
C
The transmitter efficiency ratio
D
An indication of the quality of your station's ground connection
Submit answers